How To Insulate Well | Apartment And Villa

 

 

Apartment And Villa

How to insulate well

Living in a private home, quite a natural desire to have in the house had its own well, which at any time can take useful, tasty, cool and most importantly clean water. Implement well in their area is not difficult, but the main point is the warming of the well.

How to insulate well

You will need:

- board - film - sewer

Instruction how to warm well

Step 1:

It is necessary to make a wooden shield, which is equal in size to the diameter of the ring.

Step 2:

After that, you need to wrap a custom shield film that you can protect the shield from moisture, and because of this shield will not rot. Thus you will be able to extend the shield of service for a longer time.

Step 3:

Wrapped shield must be lowered below ground level, after which it is mounted on the suspensions.

Step 4:

Above the shield installed, you will need to put a heater, as insulation foam, it is desirable to use, and it is best to use a polyethylene foam, since he is not hygroscopic.

Step 5:

After that, you must make another shield to be warm, and place it above a meter.

Step 6:

Be sure to make the ventilation, it is necessary to install a piece of ordinary pipe, for example fit 2 meter sewer pipe of small diameter. The pipe is installed through both shield.

Step 7:

If you do it so that the top panel has turned above the ground, you will need to further insulate the outside of the construct.