How To Nail Correction Of Extension | Beauty

 

 

Beauty

How to nail Correction of extension

Not all of the fair sex can boast of strong and beautiful nails from nature. However, modern materials allow any woman to always be well-groomed hands with neat manicure. But even for artificial nails is needed constant care.

How to nail Correction of extension

You will need:

- A set of abrasive saws from 150 to 4000 grit; - Wooden stick; - For edging manicure: tweezers, bath with warm water; - For neobraznogo manicure: exfoliating gel cuticle; - Antistatic brush; - Ultraviolet lamp; - The device for manicure; - Napkin or towel; - Cotton swabs; - An artificial material (gel or acrylic); - Glue for artificial nails; - Disinfectant solution; - nail polish remover; - Nourishing gel for cuticles; - Protective coating for cuticles.

Instruction how to make a correction of extension nails

Step 1:

Before correction of nails, wash your hands and treat them with a disinfectant solution. If the nails are varnished, remove it with a special liquid. Proceed to remove the cuticle. Push the cuticles with a wooden stick. If you are doing manicure, then lower your arms for a few minutes in the tub with warm water, tweezers and then cut off the dead skin. In order to not edging manicure, apply 1 - 3 minutes exfoliating gel on the cuticles stick and remove excess skin. After these procedures, dry your hands with a napkin, so that they are clean and dry.

Step 2:

Nail File 400 grit abrasive gently remove the shine from the natural nail, taking care not to damage the nail surface. Then use a sawing abrasive 150 - 180 grit and treat the places detachment artificial material. Then grind off the old sawing 2/3 of the coating thickness. Antistatic brush shake the dust. Prepare cuticle: disinfect it, treat drug supply structure of the nail and apply a protective coating.

Step 3:

Proceed to modeling. Apply a layer on each nail of your material (acrylic or gel), so that he did not get on the skin and allow it to dry for 20 seconds under a UV lamp. After the synthetic material hardens, place each hand for 2 minutes under the UV lamp. Then clean the natural nail glue and dirt from the machine for manicure.

Step 4:

Deal with a new layer of material saws, increasing their abrasiveness of between 150 and 4000 grit to get a smooth glossy surface of the artificial nail. Wash your hands and dry well. Glue the border of artificial material and the natural nail, making sure that the glue did not get to the skin. Thereafter, if desired, apply nail polish and treat the cuticle softening and nourishing oil.