How To Glue The Cone | Education

 

 

Education

How to glue the cone

Create a cone can be challenging. However, if it is necessary to perform, it is possible to have patience, to get all the materials and follow a clear plan. Plan, and glue the cut - this is all you need to do.

How to glue the cone

You will need:

paper, compass, ruler, pencil, scissors, paper glue

Instruction how to glue the cone

Step 1:

Determine the size of your future cone, as well as think about his color scheme. Record numbers on a piece of paper, so as not to get lost in the process.

Step 2:

Prepare the necessary materials: two sheets of loose paper of suitable size, glue, pencil, ruler, compass and scissors. Fold them neatly on the table, it was convenient to take them as needed. Cover the table, which will work to not spoil it in the process of creating a cone.

Step 3:

Take the first sheet of paper - and lay it on the table. That he did not roll back, fix its ancillary objects. If the table is designed only to work, secure the sheet with the buttons.

Step 4:

Now, take a pencil, a ruler - and draw a neat triangle. To taper turned out good, the sides of a triangle do the same. Be sure to check the picture on the correctness and compliance of its size desired. Cut a triangle, taking care not to damage the edge.

Step 5:

Carved triangle, connect the two sides. After fitting glue the two opposite sides of the figure. The resulting form of set aside and begin to make the bottom of the cone. To do this, take the second sheet of paper, lay it on the table and fasten well.

Step 6:

Using a compass draw a circle that will fit the diameter. To avoid mistakes, measure the diameter of the empty space of the resulting figure. Check the diameter of your drawing accuracy.

Step 7:

Now cut out the resulting circle and try on it to your future cone. If it is suitable as the bottom, you can move on to the next stage. If you missed a little, repeat the measurement again.

Step 8:

After creating suitable for the bottom of the cone, try it. If all the same, with the help of glue attach the last detail. Teeper consider the result, should get the same cone, which you planned to create.