How To Connect A Security Camera | Hi-Tech

 

 

Hi-Tech

How to connect a security camera

Surveillance cameras are connected to a power source, as well as the video processing device: recorder, quad or monitor. For this are two cables in the general box.

How to connect a security camera

Instruction how to connect a security camera

Step 1:

Open the dome cover for the camera. Its flat bottom attach to the wall and ceiling in the place of installation and secure with two screws. If the surface on which the installation is carried out, is made of concrete, use dowels.

Step 2:

Set the camera on a frameless turntable. Do not apply excessive force when tightening the screws, otherwise the board will break. Running from her three wires attach to the terminal block located on the bottom. A proper color match their destination to find out the instructions.

Step 3:

Expand the camera so as to view the necessary facilities. The cap on the bottom is not set. On-site installation of equipment to perform camera UTP-cable consisting of two twisted pairs. If you are using a common cable with four pairs, it is possible to connect two cameras placed side by side. Be sure to use a cable box.

Step 4:

Cores twisted pair selected as common, connect to the corresponding pin terminal. The remaining free wire pair selected as the signal, connect to the output terminal, and a free wire pair selected as the power - to the front.

Step 5:

Disconnect all equipment. The total core power couples connect to the negative terminal of the stabilized 12-volt power source, and the rest - to the positive. Signal pair connect to the recorder, quad or monitor, the total living must be connected to a common instrument wire.

Step 6:

Turn everything off, including the power supply. If necessary, select the appropriate input on the quad. Looking at the monitor, ask the assistant to turn the camera slowly. Get to the viewing area corresponds to the desired space.

Step 7:

Close the chamber cap, and then align the groove on it with the lens. Make sure that the camera then continues to operate, but the viewing area is not narrowed.