How To Disassemble A Casio Watch | Household

 

 

Household

How to disassemble a Casio watch

Casio Watches are manufactured in Japan. But this does not mean that they can not break. The reason for stopping the pollution is sometimes mechanism, drying oil and water from entering into the housing. If you are confident in their abilities, then try to make out the clock, wash and lubricate the mechanism. Before dismantling, carefully review all the steps.

How to disassemble a Casio watch

You will need:

- tweezers; - Cone screwdriver.

Instruction how to disassemble casio watches

Step 1:

Before disassemble Casio watches, prepare the workplace. To do this, place them in front of a white piece of paper. Remove the bracelet or strap. With the help of a special key or a pair of tweezers, remove the back of the watch. Clean the rubber gasket and carefully remove kapron ring.

Step 2:

Transferable shaft put in the time change mode, then remove. Remove the mechanism from the housing and replace the transfer roller. To do this you need to put it in the hole card to the full stop. Using a special pair of tweezers, remove the second hand, minute and hour hands, remove with a screwdriver. Try to do everything carefully, because shooters can easily break.

Step 3:

Turn the screws on the back side of the dial 90 degrees. Remove and inspect turnout gear. Check clutch and the position on the axis of the bill and watch the wheels to rotate them in this forward and reverse directions.

Step 4:

Remove the bridge anchor and anchor itself, the winding spring is completely deflate. To do this, insert a screwdriver into the screw fastening of the wheel drum, then a little to withdraw the biasing spring and wait for its complete unwinding. Carefully remove the alternate central, intermediate, and momentary escape wheel. Then examine the teeth and remove the platinum drum.

Step 5:

Wash all parts of hours in gasoline. Pour it in a small glass container so that the level does not exceed 2 cm. Please Wash larger part, then fine. Carefully clean the contaminated slots with a brush or a pointed stick. Washed details blow a jet of air from the blower. After purification take them with tweezers.